Prediction of vibration frequencies in milling using modified Nyquist method
2015 (English)In: CIRP - Journal of Manufacturing Science and Technology, ISSN 1755-5817, E-ISSN 1878-0016, Vol. 11, no November, 73-81 p.Article in journal (Refereed) Published
Study of the vibration frequencies at different cutting conditions is an alternative to the use of impact hammer test for identification of natural frequencies of the machining structure and calculation of stability lobe diagrams. Vibration frequencies not only depend on the natural frequencies of the structure, but also they are dependent on the spindle speed, damping ratio of the structure and the depth of cut. Ignoring these additional parameters would lead to errors in identification of the natural frequencies of the system and considerable deviation of the calculated stability lobe diagrams from actual cutting tests. In this study modified Nyquist method is used to investigate the effects of spindle speed, depth of cut and damping ratio of the structure on vibration frequencies. The quality of frequency prediction is compared to linear and nonlinear time domain simulations and machining experiments.
Place, publisher, year, edition, pages
Elsevier, 2015. Vol. 11, no November, 73-81 p.
Stability chart; Chatter; Nyquist stability criterion; Modified Nyquist contours; Vibration frequency; Dominant poles; Time domain simulation
Manufacturing, Surface and Joining Technology
Research subject Production Technology
IdentifiersURN: urn:nbn:se:hv:diva-8634DOI: 10.1016/j.cirpj.2015.08.006ScopusID: 2-s2.0-84949225279OAI: oai:DiVA.org:hv-8634DiVA: diva2:867907