Change search
CiteExportLink to record
Permanent link

Direct link
Cite
Citation style
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Other style
More styles
Language
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Other locale
More languages
Output format
  • html
  • text
  • asciidoc
  • rtf
Measuring the Melt Flow on the Laser Cut Front
Show others and affiliations
2015 (English)In: Physics Procedia, Vol. 78, 99-109 p.Article in journal (Refereed) Published
Abstract [en]

The flow characteristics on the laser cut front for 10 mm stainless steel AISI 304 (EN 1.4301) are studied in this paper using High Speed Imaging (HSI). The laser cut samples were produced with a 6 kW fiber laser with nitrogen gas assist. Previous work in this field has used unusual cutting parameters to make the experimentation easier. This work presents, for the first time, HSI results from standard commercially viable cutting parameters. This was made possible by the development of a new experimental technique. The results presented here suggest that the cut front produced when cutting stainless steel with a fiber laser and a nitrogen assist gas is covered in bumps which themselves are covered in a thin layer of liquid. Under the conditions shown here the bumps move down the cut front at an average speed of approximately 0.4m/s. The liquid flows at an average speed of approximately 1.1m/s. The average melt depth at the bottom of the cut zone under these conditions is approximately 0.17 mm.

Place, publisher, year, edition, pages
2015. Vol. 78, 99-109 p.
National Category
Manufacturing, Surface and Joining Technology
Identifiers
URN: urn:nbn:se:hv:diva-11759DOI: 10.1016/j.phpro.2015.11.022OAI: oai:DiVA.org:hv-11759DiVA: diva2:1150949
Note

Validerad; 2015; NivÄ 1; 20151126 (andbra); Konferensartikel i tidskrift

Available from: 2017-10-20 Created: 2017-10-20 Last updated: 2017-10-23Bibliographically approved

Open Access in DiVA

No full text

Other links

Publisher's full text

Search in DiVA

By author/editor
Pocorni, Jetro
Manufacturing, Surface and Joining Technology

Search outside of DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric score

doi
urn-nbn
Total: 5 hits
CiteExportLink to record
Permanent link

Direct link
Cite
Citation style
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Other style
More styles
Language
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Other locale
More languages
Output format
  • html
  • text
  • asciidoc
  • rtf