Endre søk
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Inaccuracy in arc power calculation through a product of voltage and current averages
Högskolan Väst, Institutionen för ingenjörsvetenskap, Avdelningen för svetsteknologi (SV). Center for Research and Development of Welding Processes (Laprosolda), Federal University of Uberlandia (UFU), Uberlândia, MG (BRA). (PTW)ORCID-id: 0000-0002-1005-5895
Department of Food Engineering, Federal University of Mato Grosso (UFMT), Cuiabá (BRA).ORCID-id: 0000-0001-8509-9828
Högskolan Väst, Institutionen för ingenjörsvetenskap, Avdelningen för Matematik, Data- och Lantmäteriteknik.ORCID-id: 0000-0003-0067-8631
2022 (engelsk)Inngår i: Journal of the Brazilian Society of Mechanical Sciences and Engineering, ISSN 1678-5878, E-ISSN 1806-3691, Vol. 44, nr 1, s. 1-9, artikkel-id 11Artikkel i tidsskrift (Annet vitenskapelig) Published
Abstract [en]

Power is an indirect measurand, determined by processing voltage and current analogue signals through calculations. Using arc welding as a case study, the objective of this work was to bring up subsidies for power calculation. Based on the defnitions of correlation and covariance in statistics, a mathematical demonstration was developed to point out the diference between the product of two averages (e.g. P=UxI) and the average of the products (e.g. P=(UxI). Complementarily, a brief on U and I waveform distortion sources were discussed, emphasising the diference between signal standard deviations and measurement errors. It was demonstrated that the product of two averages is not the same as the average of the products, unless in specifc conditions (when the variables are fully correlated). It was concluded that the statistical correlation can easily fag the interrelation, but if assisted by covariance, these statistics quantify the inaccuracy between approaches. Finally, although the statistics' determination is easy to implement, it is proposed that power should always be calculated as the average of the instantaneous U and I products. It is also proposed that measurement error sources should be observed and mitigated, since they predictably interfere in power calculation accuracy.

sted, utgiver, år, opplag, sider
Brazilian Society of Mechanical Sciences and Engin , 2022. Vol. 44, nr 1, s. 1-9, artikkel-id 11
Emneord [en]
Electrical power measurement, Arc welding, Instantaneous power, Probability theory, Covariance, Correlation
HSV kategori
Forskningsprogram
Produktionsteknik
Identifikatorer
URN: urn:nbn:se:hv:diva-17966DOI: 10.1007/s40430-021-03317-6ISI: 000728176000002Scopus ID: 2-s2.0-85120972487OAI: oai:DiVA.org:hv-17966DiVA, id: diva2:1622651
Merknad

Creative Commons Attribution 4.0 International License

Tilgjengelig fra: 2021-12-23 Laget: 2021-12-23 Sist oppdatert: 2024-04-12bibliografisk kontrollert

Open Access i DiVA

Fulltekst mangler i DiVA

Andre lenker

Forlagets fulltekstScopus

Person

Scotti, AmericoEshagh, Mehdi

Søk i DiVA

Av forfatter/redaktør
Scotti, AmericoBatista, Márcio AndradeEshagh, Mehdi
Av organisasjonen
I samme tidsskrift
Journal of the Brazilian Society of Mechanical Sciences and Engineering

Søk utenfor DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric

doi
urn-nbn
Totalt: 130 treff
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf