Endre søk
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Improving the lifetime of suspension plasma sprayed thermal barrier coatings
Högskolan Väst, Institutionen för ingenjörsvetenskap, Avdelningen för avverkande och additativa tillverkningsprocesser (AAT). (PTW)ORCID-id: 0000-0002-4201-668X
Högskolan Väst, Institutionen för ingenjörsvetenskap, Avdelningen för avverkande och additativa tillverkningsprocesser (AAT). (PTW)ORCID-id: 0000-0002-9578-4076
Siemens Industrial Turbomachinery AB, Finspong, Sweden.
Linköping University, Linköping, Sweden.
2017 (engelsk)Inngår i: Surface & Coatings Technology, ISSN 0257-8972, E-ISSN 1879-3347, Vol. 332, s. 550-559Artikkel i tidsskrift (Fagfellevurdert) Published
Abstract [en]

Development of thermal barrier coating systems (TBCs) for gas turbine applications allowing higher combustion temperatures is of high interest since it results in higher fuel efficiency and lower emissions. TBCs produced by suspension plasma spraying (SPS) have been shown to exhibit significantly lower thermal conductivity as compared to conventional systems due to their very fine porosity microstructure. However they have not been commercialised yet due to low reliability and life expectancy of the coatings. In addition to the initial topcoat microstructure and its sintering resistance, lifetime of a TBC system is highly dependent on bondcoat chemistry as it influences the growth rate of thermally grown oxide (TGO) layer. To enhance the lifetime of SPS TBCs, fundamental understanding of relationships between topcoat microstructure and its evolution with time, bondcoat chemistry, TGO growth rate, and lifetime is essential. The objective of this work was to study the effect of topcoat microstructure evolution and TGO growth rate on lifetime in SPS TBC systems. Experimental MCrAlY bondcoat powders with different aluminium activities were investigated and compared to a commercial bondcoat powder. High velocity air fuel spraying was used for bondcoat deposition while axial-SPS was used for yttria stabilized zirconia topcoat deposition. Lifetime was examined by thermal cyclic fatigue testing. Isothermal heat treatment was performed to study TGO evolution with time. The changes in microstructure of SPS coatings due to sintering under long term exposure at high temperatures were investigated. Different failure modes in SPS TBCs were also examined. The bondcoat with higher aluminium activity resulted in a significantly higher thermal cyclic lifetime of the corresponding TBC as it could have promoted protective alumina layer growth for a longer period of time. The results indicate that the significant changes in topcoat microstructure due to sintering as observed in this work could have a detrimental effect on TBC lifetime. © 2017 Elsevier B.V.

sted, utgiver, år, opplag, sider
2017. Vol. 332, s. 550-559
Emneord [en]
Air; Alumina; Aluminum; Coatings; Combustion; Deposition; Fatigue testing; Gas emissions; Gas turbines; Growth rate; Microstructure; Plasma jets; Plasma spraying; Sintering; Sprayed coatings; Thermal conductivity; Thermal spraying; Yttria stabilized zirconia; Zirconia, Bond coats; Lifetime; Suspension plasma spraying; Thermal barrier coating (TBCs); Thermally grown oxide, Thermal barrier coatings
HSV kategori
Forskningsprogram
TEKNIK, Produktions- och materialteknik
Identifikatorer
URN: urn:nbn:se:hv:diva-11885DOI: 10.1016/j.surfcoat.2017.07.078ISI: 000418968100064Scopus ID: 2-s2.0-85029643304OAI: oai:DiVA.org:hv-11885DiVA, id: diva2:1163006
Forskningsfinansiär
Knowledge Foundation, 20160022Tilgjengelig fra: 2017-12-05 Laget: 2017-12-05 Sist oppdatert: 2019-05-23bibliografisk kontrollert

Open Access i DiVA

Fulltekst mangler i DiVA

Andre lenker

Forlagets fulltekstScopus

Personposter BETA

Gupta, Mohit KumarMarkocsan, Nicolaie

Søk i DiVA

Av forfatter/redaktør
Gupta, Mohit KumarMarkocsan, Nicolaie
Av organisasjonen
I samme tidsskrift
Surface & Coatings Technology

Søk utenfor DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric

doi
urn-nbn
Totalt: 89 treff
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf