Öppna denna publikation i ny flik eller fönster >>2016 (Engelska)Ingår i: CIRP - Journal of Manufacturing Science and Technology, ISSN 1755-5817, E-ISSN 1878-0016, Vol. 13, s. 46-50Artikel i tidskrift (Refereegranskat) Published
Abstract [en]
The search for increased productivity can be interpreted as the increase of material removal rate (MRR). Namely, increase of feed, depth of cut and/or cutting speed. The increase of any of these three variables, will increase the tool wear rate; therefore decreasing its tool life according to the same tool life criteria. This paper proposes an integrated model for efficient selection of cutting data for maximal MRR and maximal tool utilization. The results show that, it is possible to obtain a limited range of cutting parameters from where the CAM Programmer can select the cutting data assuring both objectives.
Nyckelord
Materials removal rate (MRR), tool life, tool wear, cutting data, optimization
Nationell ämneskategori
Bearbetnings-, yt- och fogningsteknik
Forskningsämne
Produktionsteknik; TEKNIK, Produktions- och materialteknik
Identifikatorer
urn:nbn:se:hv:diva-8674 (URN)10.1016/j.cirpj.2016.02.002 (DOI)000376092800005 ()2-s2.0-84960153710 (Scopus ID)
Forskningsfinansiär
KK-stiftelsen
Anmärkning
Ingår i licentiatuppsats. Available online 12 March 2016
2015-11-172015-11-172019-12-03Bibliografiskt granskad